Toho-electronics TTM200 Manuel d'utilisateur télécharger pdf (Page 16)

5.2 Setting a data length

5.3 Setting a stop bit length

5.4 Setting a parity

5.5 Setting a BCC check

The BCC check is disabled.

Stop bit 1

Stop bit 2

No parity

Odd parity

Even parity

Data length, 7 bits

Data length, 8 bits

Communication parameter

5.6 Setting a communications speed

While in the "Set a communications speed" screen on the preceding page, operate the ▲ and ▼

keys to make the settings. The initial value is 9.6.

2400 BPS

4800 BPS

9600 BPS

19200 BPS

38400 BPS

Communication parameter

5.7 Setting an address

While in the "Set a communications address" screen on the preceding page, operate the ▲ and ▼

keys to make the settings. The initial value is 1.

Setting range: 1 to 99 stations

(It cannot be set to a 0.)

5.8 Setting a response delay

Set a time from the time when the high-level computer finished sending a "request message" until

the time when it delivers the line and enters an input state.

While in the "Set a response delay" on the preceding page, operate the ▲ and ▼ keys to make the

settings. The initial value is 0.

Setting range: 0 to 250msec

* If the response delay is set to a short setting, the communications may not be conducted normally.

* In a real operation, the processing time for this product will be added, in addition to the response

delay.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 50 51

Pas de commentaire

Toho-electronics TTM200 Manuel d'utilisateur Page 16