Toho-electronics TTM200 Manuel d'utilisateur télécharger pdf (Page 15)

5. Settings regarding MODBUS communications

5.1 Overview

Before communications is performed, initial settings must be made on this product. Enter such

settings with the keys on the front panel.

To switch to a series of setting screens, take the steps described below.

For details, see the operation manual furnished with this product.

Back to communications setting mode

Power-on

Initial setting

Power-on

Initial setting

For MODBUS (RTU) For MODBUS (ASCII)

Setting item selection mode

Communication protocol setting

1: MODBUS (RTU) (initial value: 0)

Communication parameter setting

Communication speed setting

Communication address setting

Response delay time setting

MODE key

4 seconds

Operation mode screen

MODE key at least 2 seconds

Setting item selection mode

▲/▼ key

Back to communications setting mode

MODE key

Setting item selection mode

Communication protocol setting

2: MODBUS (ASCII) (initial value: 0)

Communication parameter setting

Communication speed setting

Communication address setting

Response delay time setting

MODE key

4 seconds

Operation mode screen

MODE key at least 2 seconds

Setting item selection mode

▲/▼ key

MODE key

When the settings are over, press the MODE key at least 2 seconds to go back to the operation mode.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 50 51

Pas de commentaire

Toho-electronics TTM200 Manuel d'utilisateur Page 15