Toho-electronics TTM200 Manuel d'utilisateur télécharger pdf (Page 119)

48-7009-E 5-49

5.5.2 SET 21 program function setting

■ The SET 21 program function setting is for setting operating method of a program run.

Set the setting values for the following: “program run mode,” “power failure compensation range,”

“time unit,” “WAIT range” and “Program run start/stop.”

The flowchart below is for “SET 21 program function setting.”

Note Note that some screens do not appear depending on setting values. Characters indicated in

parentheses are those displayed on a screen.

[Setting flow]

SET 21 (PGF)

Setting the program

function setting mode

SET 21 (C/P)

Selecting an operating

type setting

II.

When C/P  1:

Operating type setting *1

I. When C/P  0 (program run OFF)

II. When C/P  1 (program run ON)

SET 21 (PGMd)

Selecting a program mode

When C/P  0:

SET 21 returns to

the beginning.

Power failure compensation range setting *3

Displayed only with presence of power failure

compensation for the program mode setting.

Otherwise, none is displayed.

IV.

When PGMD  2 or 3:

SET 21 (PoC)

Setting the power failure

compensation range

III.

When PGMD  0 or 1:

SET 21 (H/MP)

Selecting time unit

Time unit setting *4

V. When H/MP  0 or 3 (step time)

VI. When H/MP  1, 2, 4 or 5 (soak time)

When H/MP  0 or 3:

VI.

When H/MP  1, 2, 4 or 5

SET 21 (WAIt)

Setting the WAIT range

WAIT width setting *5

Displayed only with the soak time settings for time

unit. None is displayed with step time.

SET 21 returns to the beginning.

Program mode setting *2

III. When PGMd  0 or 1 (program run ON)

IV. When PGMd  2 or 3 (program run ON;

with power failure compensation)

The next page describes the content of each setting value.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 263 264

Commentaires sur ces manuels

Pas de commentaire

Toho-electronics TTM200 Manuel d'utilisateur Page 119

Commentaires sur ces manuels