48-7009-E 6-7
■ PV filter setting
The PV filter setting is a function that demonstrates the CR filter effect on software through performing a first-order lag calculation for
PV of the input 1.
The filter effect is set using the time constant [t].
(Time constant is defined as the time required for PV to reach about 63 % when an input changes in a step configuration.)
* CR filter --- a filter of first-order lag
Note Application of PV filter
(1) Effect of noise is alleviated due to elimination of high-frequency noise when electric noise applies on inputs.
(2) Response can be delayed against abrupt change of an input.
■ Input signal
■ Input read in
When no digital PV filter exists
[Time constant (t) = 0]
When a digital PV filter exists
[Time constant (t) > 0]
■ Decimal point position setting
Thermocouple/resistance temperature detector input
A decimal point position is set for PV of the input 1.
■ °C/°F switchover
Press the MODE key for making a setting effective (including
reverse feed).
Set the unit of temperature input.
Note Switchover of °C/°F may result in change of each setting value due to limits being applied, such as SLH, SLL, tRH and
tRL.
Commentaires sur ces manuels